Magicrete Putty Plus

dry mix mortar manufacturer

Putty Plus is a polymer modified white cement based wall putty specially developed as a finishing coat to cover the unevenness and pinholes created by plastering and to prepare the wall/ surface for painting.

It can also be treated as a base coat for painting.

Putty Plus adheres to ‘Housing Development Board of Singapore’ standards and is specially formulated using German make polymers to impart classy finish to walls and ease of work to applicators.

Putty Plus is available in Fine & Coarse variants.

Wall putty
dry mix mortar manufacturers & suppliers Features
Feature icon19
75% Extra Water Resistant*
Feature icon18
8% Extra Smooth Finish*
Feature icon21
10% Extra Workability*
Feature icon20
UV Resistance
Feature icon1
25% Extra Strong Bonding*
Feature icon7
11% Extra Economical*
dry mix mortar manufacturers & suppliers Advantages

No requirement of primer


Protects expensive paint from flaking, dampening and peeling off

Smooth finish

Reduces paint consumption


Superior paint finish

Technical Specifications
Appearance White Powder
Initial/Final Setting Time 270/300 Min
Tensile Adhesion Strength > 1.0 MPa in 28 days
Compressive Strength (MPa) 8.5 MPa in 28 days
Flexural Strength 2.1 MPa in 28 days
Water Retentivity 99.60%
Pot Life 90-100 Min
pH 9.2- 10.1
Coverage (1-1.5 mm coat) 12-15 Sq Ft/kg depending on wall finish
*Specifications may vary, due to continuous product development

Preparation & Application

Surface Preparation
  • The surface application should be free from loose particles, grease or any other foreign material. For uneven areas, re-plaster them with Magicplast-Gypsum Plaster or Magicplast-Readymix Plaster
  • Mix 1kg of Putty Plus in 350-400 ml of water in clean bucket and not vice versa
  • Mix continuously by hand or using an electrical stirrer to obtain a homogenous lump-free paste
  • Leave the mix to slake for 10 minutes
  • Remix the paste for about 2 minutes before use
  • Use the mixture within 30 minutes of preparation
  • Dampen the surface to be plastered with clean water
  • Use a steel trowel/blade to apply the mixture of about 0.5-1 mm thickness
  • Level and smoothen the surface and cure the first coat lightly once it dries
  • Apply the second coat of 0.5-1 mm thickness once the first coat is fully dried and set
  • The thickness of each coat should not exceed 1mm and the total thickness of plaster should not be more than 2 mm


MagicPlast Wall Putty Brochure